Mcculloch mac 2816 user manual

Take care not to misplace the retaining knob or spring. Measure and cut 18 feet of 0.

Report Abuse

Insert both ends into one set of paired holes on the spool's center -- one end through one hole, the other through the remaining hole. Pull both ends though the holes evenly and completely until no slack remains and line is securely looped through the spool holes. Beginning at the spool, grasp both strings and wrap them evenly in a clockwise direction around the spool until you're left with approximately 6 inches of line. Insert one string end through one of two opposing external spool holes, repeating with the other string end end through the opposite hole.

Reassemble the string head in the reverse order in which you disassembled it and trim the exposed line to 5 inches or less before starting the McCulloch MAC Mix fresh gasoline in a Pour one-half of the gasoline in to the container, add the proper amount of two-stroke oil -- detailed instructions with sample fuel and oil quantities will be printed on the oil container. Add the remaining gasoline, cap the container and swirl gently to mix.

McCulloch Trimmer 28cc User Guide | izyhapineh.cf

If the gasoline will be stored for more than one month, add fuel stabilizer to the mixture, following label instructions. Using old or untreated gasoline may cause hard starting and poor engine performance. You can also buy ready-mixed oil and fuel at home improvement stores.

McCulloch Trimmer Idle Adjustment

Ensure the ignition switch is in the "on" position. Slide the choke lever to the marked "choke" position and press the rubber carburetor priming bulb 10 times. Grasp the grip with one hand while pulling up on and holding the throttle trigger with your finger. Pull the starter handle four times, slide the choke lever to the "start" position and pull the start handle four more times until the engine is running.

Once the engine has run for 10 seconds, slide the choke lever to "run" and release the throttle trigger.

How do I replace the head nylon string?

If the engine fails to start, start over from the beginning. To start a warm engine, depress the throttle trigger, slide the choke lever to "start" or "run" and pull the starter handle four times. To shut the engine down, turn the switch to the "off" position. Ensure the engine switch is turned to "off" and the engine is cool before performing maintenance on the McCulloch MAC Clean the spark plug by gently pulling the wire boot off. Insert a spark plug wrench and remove the plug by turning counterclockwise and pulling the plug outward.


  • microsoft word document for mac free?
  • perkembangan terkini lahad datu 7 mac.
  • McCulloch 28cc Trimmer User Manual;
  • McCulloch 28cc Illustrated Parts List?
  • Local Store Availability;

Inspect the electrode, clean it with emery cloth, if necessary, check for 0. If the ceramic insulation is cracked, install a new spark plug.

Clean the air filer by removing the two air filter cover screws with a screwdriver. Remove the air filter, wash it with soap and water, allow it to air dry and reinstall it. Clean or replace the spark arrester screen by inserting a screwdriver into the slot in the muffler shield. Turn the retaining screw counterclockwise and remove the spark arrester cover and screen.

Clean the screen with a utility brush or replace it if it is damaged.

Model #PRO MAC II-11400132-04 Mcculloch line trimmers/weedwackers, gas

Change language. We use cookies to improve your experience on our website. By continuing to browse this website you are agreeing to our use of cookies. Find out more by reading about our Cookies. How do I replace the head nylon string? Instructions for how to refill the trimmer head with new nylon string.

Account Options

Accessories, Trimmer. Related articles. How to mount the trimmer head or cutting blade Easy-to-understand DIY tips on how to mount a trimmer head and a cutting blade on your McCulloch trimmer.


go to site admin